Safari Van 2WD V6-4.3L VIN X (2003)
4. Use J 38778 in order to release the molding retainers.
INSTALLATION PROCEDURE
1. Install the door garnish molding to the vehicle:
1.1.
Align the retainers to the holes in the door.
1.2.
Press the panel in order to engage the retainers into the door.
2. Install the door handle bezel to the door.
3. Install the door handle bezel screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the door handle bezel screws to 2 N.m (18 lb in).
4. Install the swing-out window latch to the door, if equipped.
Garnish Molding Replacement - Upper Roller Track
GARNISH MOLDING REPLACEMENT - UPPER ROLLER TRACK
TOOLS REQUIRED
J 38778 Door Trim Pad and Garnish Clip Remover
REMOVAL PROCEDURE
1. Remove the retaining screws from the upper garnish molding.
