Safari Van 2WD V6-4.3L VIN X (2003)
Trim Panel: Service and Repair
Garnish Molding Replacement - LF Lock Pillar
GARNISH MOLDING REPLACEMENT - LF LOCK PILLAR
REMOVAL PROCEDURE
1. Remove the retaining screw from the garnish molding.
2. Remove the driver's side seat belt upper mounting bolt.
3. Pull back on the garnish molding in order to release the fasteners.
4. Remove the garnish molding from the pillar.
INSTALLATION PROCEDURE
1. Install the garnish molding to the pillar:
1.1.
Align the locator pin with the pillar.
1.2.
Press the locator pin firmly into place, seating all fasteners.
2. Install the driver's seat belt upper mounting bolt.
3. Install the garnish molding retaining screw.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the garnish molding retaining screw to 2 N.m (18 lb in).
Garnish Molding Replacement - Rear Upper
