Safari Van 2WD V6-4.3L VIN X (2003)
Keyless Entry Receiver: Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left knee bolster.
2. Disconnect the remote keyless entry antenna (2) from the receiver (5).
3. Disconnect the remote keyless entry electrical connector (4) from the receiver (5).
4. Remove the remote keyless entry module screws from the bracket (3).
5. Remove the remote keyless entry module from the carrier.
INSTALLATION PROCEDURE
1. Install the remote keyless entry module to the carrier.
2. Install the remote keyless entry module screws to the bracket (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the remote keyless entry module screws to the bracket (3) to 2 N.m (18 lb in).
3. Connect the remote keyless entry antenna (2) to the receiver (5).
4. Connect the remote keyless entry electrical connector (4) to the receiver (5).
5. Install the left knee bolster.
6. Reprogram the transmitter. See: Testing and Inspection/Programming and Relearning