Safari Van 2WD V6-4.3L VIN X (2003)
29. While guiding the forming mandrel into the exposed end of pipe to be flared, operate the lever of the J 45405 until the forming mandrel bottoms
against the clamping dies.
30. Rotate the hydraulic fluid control valve counterclockwise to the open position in order to allow the forming ram to retract.
31. Insert the finishing cone into the forming ram.
32. Rotate the body of the J 45405 until it bottoms against the die cage.
33. While guiding the finishing cone into the exposed end of pipe to be flared, operate the lever of the J 45405 until the finishing cone bottoms against
the dies.
34. Rotate the hydraulic fluid control valve counterclockwise to the open position in order to allow the hydraulic forming ram to retract.
35. Loosen the die clamping screw and remove the dies and pipe.
36. Lightly tap the dies on a bench until the die halves separate.
37. Visually inspect the brake pipe flare for correct shape and size.
38. Using a suitable brake pipe bending tool, shape the new pipe using the removed section of pipe as a template.
