Safari Van 2WD V6-4.3L VIN X (2003)
6. Remove the cable from the lever.
7. Remove the cable.
Installation Procedure
1. Install the cable taking care to correctly route the cable through the guide and the bracket.
2. Attach the cable to the lever.
3. Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place.
4. Install the cable to the differential clip.
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
