Safari Van 2WD V6-4.3L VIN X (2003)
Coolant Line/Hose: Service and Repair
Engine Oil Cooler Pipe/Hose Quick Connect Fitting
Engine Oil Cooler Pipe/Hose Quick Connect Fitting
Removal Procedure
1. Using a bent-tip screwdriver or equivalent, pull on one of the open ends of the retaining ring in order to rotate the retaining ring.
2. Rotate the retaining ring around the quick connector until the retaining ring is out of position and can be completely removed.
Discard the retaining rings.
3. Remove the engine oil cooler line from the quick connector fitting at the radiator.
Pull the lines straight out from the connectors.
4. Clean all of the components in a suitable solvent, and dry them with compressed air.
5. Inspect the fittings, the connectors, the cooler lines, and the cooler for damage, distortion, or restriction. Replace parts as necessary.
Installation Procedure
Important: When performing the following procedure, do not reuse the old retaining rings. Replace the old retaining rings with new ones.
Do not install the new retaining ring onto the fitting by pushing the retaining ring down over the fitting.
