Safari Van 2WD V6-4.3L VIN X (2003)
11. Disconnect the following electrical connectors:
^
The A/C compressor clutch, if equipped (1)
^
The A/C high pressure cutoff switch, if equipped (5)
^
The throttle position (TP) sensor (2)
^
The idle air control (IAC) motor (3)
^
The fuel meter body assembly connector (4)
12. Disconnect the following electrical connectors:
^
The manifold absolute pressure (MAP) sensor (4)
^
The EVAP canister purge solenoid valve (1)
13. Remove the ground wire from the stud at the water outlet.
14. Remove the nut, and remove the engine wiring harness bracket from the stud, at the EVAP canister purge solenoid valve.
15. Move and secure the engine wire harness out of the way.
