Safari Van 2WD V6-4.3L VIN X (2003)
Blower Motor Resistor: Service and Repair
Blower Motor Resistor Assembly Replacement (With RPO Code C60)
BLOWER MOTOR RESISTOR ASSEMBLY REPLACEMENT (With RPO Code C60)
REMOVAL PROCEDURE
IMPORTANT: The blower motor relay is an integral part of the blower motor resistor and can not be serviced separately from the resistor.
1. Remove the air cleaner.
2. Remove the windshield washers and the coolant reservoir.
3. Disconnect the electrical connectors.
4. Remove the screws from the blower motor resistor assembly.
5. Remove the blower motor resistor assembly (4).
INSTALLATION PROCEDURE
1. Install the blower motor resistor assembly (4).
2. Install the screws to the blower motor resistor assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 2 N.m (18 lb in).
3. Connect the electrical connectors.
4. Install the windshield washers and the coolant reservoir.
