Safari Van 2WD V6-4.3L VIN X (2003)
8. With the compressor mounted on the J 34992, position the pulley rotor (1) and the bearing assembly on the front head.
9. Position the J 33017 and the J 33023-A directly over the inner race of the bearing.
10. Position the J 8433-1 on the J 33023-A.
11. Assemble the 2 through bolts and the washers through the puller bar slots.
12. Thread the through bolts into the J 34992.Ensure that the thread of the through bolts engage the full thickness of the J 34992.
13. Tighten the center screw in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the compressor front head.If the J 33017 slips
off direct in-line contact with the inner race of the bearing, perform the following steps:
13.1. Loosen the J 8433-3.
13.2. Realign the installer and the pilot in order to ensure that the J 33017 properly clears the front head.
14. Use the snap ring pliers in order to install the following components:
14.1. The pulley rotor (1)
14.2. The retaining ring (2)
14.3. Install the clutch plate and hub assembly.
14.4. Install the A/C compressor.
