Safari Van 2WD V6-4.3L VIN X (2003)
Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Remove the center high-mounted stop lamp retaining screws.
2. Gently pull the electrical connector through the top of the roof.
3. Disconnect the electrical connector.
4. Remove the high-mounted stop lamp from the vehicle.
INSTALLATION PROCEDURE
1. Install the high-mounted stop lamp to the vehicle.
2. Connect the electrical connector.
3. Carefully push the electrical connector back into the roof.
4. Install the high-mounted stop lamp retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 2 N.m (18 lb in).