Safari Van 2WD V6-4.3L VIN X (2003)
1. Install the seal washers.
2. Install the tube to the auxiliary evaporator module.
3. Install the nut that retains the tube to the auxiliary evaporator module.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nut to 25 N.m (18 lb ft).
4. Install the bolts that retain the clips on the tubes to the body.
Tighten
Tighten the bolts to 4 N.m (35 lb in).
5. Install the auxiliary evaporator rear tube inlet tube to the auxiliary evaporator inlet side tube.
Tighten
Tighten the nut to 27 N.m (20 lb ft).
6. Install the auxiliary evaporator rear tube outlet tube to the auxiliary evaporator outlet side tube.
Tighten
Tighten the nut to 47.5 N.m (35 lb ft).
