Safari Van 2WD V6-4.3L VIN X (2003)
4. Install the auxiliary evaporator side inlet tube to the auxiliary evaporator front inlet tube (2).
Tighten
Tighten the nut to 27 N.m (20 lb ft).
5. Install the new O-ring seal. Coat the O-ring seal with 525 viscosity refrigerant oil.
6. Install the auxiliary evaporator side inlet tube (3) to the auxiliary evaporator rear tube.
Tighten
Tighten the nut to 27 N.m (20 lb ft).
7. Lower the vehicle.
8. Evacuate and recharge the system.
9. Leak test the fittings of the component using the J 39400-A.
Suction Screen Installation
SUCTION SCREEN INSTALLATION
TOOL REQUIRED
J 44551 Suction Screen Kit
IMPORTANT: Suction screens are intended to be installed in the suction hose after a major compressor failure.
The suction screens are available in 3 different sizes.
