Safari Van 2WD V6-4.3L VIN X (2003)
Evaporative Emissions Hose: Service and Repair
EVAP Hoses/Pipes Replacement - Engine/Chassis
REMOVAL PROCEDURE
1. Remove the engine cover.
2. Clean all the pipe connections and the surrounding areas before disconnecting the pipes in order to avoid possible contamination.
3. Disconnect the chassis EVAP pipe from the engine compartment EVAP purge pipe (9).
4. Raise the vehicle. Refer to Vehicle Lifting.
5. Remove the fuel/EVAP pipes bundle retainer mounting stud (7) from the cylinder head.
6. Remove the fuel/EVAP pipes bundle retainer mounting stud (6) from the transmission.
7. Remove the fuel/EVAP pipes bundle retainer mounting fastener (5) from the crossrail.
8. Disconnect the front chassis EVAP purge pipe from the rear chassis EVAP purge pipe (4).
9. Note the position of the EVAP pipe for aid in installation.
10. Remove the EVAP pipe from the retaining clips.
11. Remove the EVAP pipe.
INSTALLATION PROCEDURE
