Safari Van 2WD V6-4.3L VIN X (2003)
Fuel Line Coupler: Service and Repair
Quick Connect Fitting(S) Service (Metal Collar)
TOOLS REQUIRED
J 37088-A Fuel Line Disconnect Tool Set
REMOVAL PROCEDURE
1. Relieve the fuel system pressure before servicing any fuel system connection. Refer to Fuel Pressure Relief Procedure.
2. Remove the retainer from the quick-connect fitting.
3. Blow dirt out of the fitting using compressed air.
CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.
4. Choose the correct tool from J 37088-A tool set for the size of the fitting. Insert the tool into the female connector, then push inward to release the
locking tabs.
5. Pull the connection apart.
6. Using a clean shop towel, wipe off the male pipe end.
NOTE: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs.
Clean or replace the components and assemblies as required.
7. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.
INSTALLATION PROCEDURE
