Safari Van 2WD V6-4.3L VIN X (2003)
6. Install the fuel pipe grommet (4) into the crossrail. Lubricate the grommet to aid in the installation.
7. Install the fuel pipe retainer to the crossrail.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
-
Tighten the fuel pipe crossrail retainer to 11 N.m (97 lb in).
-
Tighten the fuel feed pipe to fuel filter fitting to 27 N.m (20 lb ft) using a back-up wrench.
-
Tighten the fuel return pipe to coupler fitting to 27 N.m (20 lb ft) using a back-up wrench.
1. Apply a few drops of clean engine oil to the rear male connector pipe ends.
2. Connect the fuel return (5) and the fuel feed (2) pipes to the fuel tank pipes (1).
3. Connect the negative battery cable.
4. Inspect for fuel leaks.
4.1.
Turn ON the ignition, with the engine OFF, for 2 seconds.
4.2.
Turn OFF the ignition for 10 seconds.
4.3.
Turn ON the ignition, with the engine OFF.
4.4.
Inspect for fuel leaks.
5. Install the engine cover.
