Safari Van 2WD V6-4.3L VIN X (2003)
4. Position the tool J 41364-A onto the park/neutral position switch. Ensure that the two slots on the switch where the manual shaft is inserted are
lined up with the lower two tabs on the tool.
5. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
6. Tighten the bolts securing the switch to 25 Nm (18 lb.ft).
7. Remove the J 41364-A from the switch. If installing a new switch, remove the positive assurance bracket at this time.
8. Connect the electrical connectors to the switch.
