Safari Van 2WD V6-4.3L VIN X (2003)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Removal Procedure
Important: After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.
1. Remove the fuel pipe shield (3) from the frame bracket (2) by removing the 2 nuts (4).
Important: Thoroughly wash all contaminants from around the EHCU (1). The area around the EHCU must be free from loose dirt to prevent
contamination of disassembled ABS components.
2. Disconnect the electrical connectors from the EBCM.
3. Remove the mounting screws (1) that fasten the EBCM (2) to the BPMV (5).
4. Remove the EBCM (2) from the BPMV (5). Removal may require a light amount of force.
Important: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
5. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
Installation Procedure
Important: Do not reuse the old mounting screws (1). Always install new mounting screws with the new EBCM.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
