Safari Van 2WD V6-4.3L VIN X (2003)
5. Disconnect the power steering pump remote reservoir hose from the power steering pump.
6. Raise and support the vehicle. Refer to Vehicle Lifting.
7. Remove the power steering pump rear mounting bracket nut.
8. Lower the vehicle.
9. Loosen the accessory bracket bolts and nut. Pull the accessory bracket forward.
10. Remove the power steering pump mounting bolts.
11. Remove the power steering pump and the power brake booster inlet hose from the vehicle.
12. Remove the power brake booster inlet hose from the power steering pump.
Installation Procedure
1. Install the power brake booster inlet hose to the power steering pump.
2. Install the power steering pump and the power brake booster inlet hose to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the power steering pump mounting bolts.
-
Tighten the power steering pump mounting bolts to 50 Nm (37 ft. lbs.).
4. Reposition the accessory mounting bracket and tighten the bolts and nut.
-
Tighten the accessory mounting bracket bolts to 50 Nm (37 ft. lbs.).
-
Tighten the accessory mounting bracket nut to 41 Nm (30 ft. lbs.).
