Safari Van 2WD V6-4.3L VIN X (2003)
2. Connect the steering wheel module yellow 2-way connector (1) located left of the steering column near the knee bolster.
3. Install the CPA to the steering wheel module yellow 2-way connector (1) located near the knee bolster.
4. Install the AIR BAG fuse to the I/P fuse block (1) located in the I/P fuse block.
5. Install the knee bolster.
6
Staying well away from all air bags, turn ON the ignition, with the engine OFF.
6.1.
The AIR BAG indicator will flash 7 times.
6.2.
The AIR BAG indicator will then turn OFF.
7. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
Zone 5
1. Remove the key from the ignition.
2. Connect the I/P module yellow 2-way connector (1) located behind the main I/P support.
