Safari Van AWD V6-262 4.3L VIN W CPI (1992)
ACCELERATOR CONTROL CABLE
When performing service on the accelerator control cable, observe the following:
-
The retainer must be installed with the tangs secured overhead of the stud.
-
The conduit fitting at both ends of the cable must have the locking tangs expanded and locked in the attaching holes.
-
The braided portion of the accelerator cable assembly must not come in contact with the front of the dash sealer during assembly, repair, or
replacement of the assembly.
-
The flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2 inches) of the moving parts of the accelerator linkage
outboard of the support unless the routing is positively controlled.
REMOVE/DISCONNECT
-
Retainer from throttle lever stud
-
Retainer locking tangs from support bracket
-
Retainer from accelerator pedal rod or release cable from rod.
-
Retainer locking tangs from dash panel
INSTALL/CONNECT
-
Retainer to dash panel.
-
Retainer to accelerator pedal rod or connect cable in rod slot.
-
Retainer to support bracket.
-
Retainer to throttle lever stud or connect cable to pulley.
