Safari Van AWD V6-262 4.3L VIN W CPI (1992)
A.
Mark the adjustment bolt (184) setting.
B.
Increase the tension on the adjustment arm (186) using J 22517-C.
C.
Remove adjustment bolt (184) and retaining plate (185).
D.
Move the tool aside.
3.
Torsion bar anchor adapter.
A.
Slide the adapter out toward the rear.
B.
Remove the adjustment arm (186).
4.
Torsion bar (182).
^
Note the location of the tape at the rear ends of the torsion bars. There are different bars for the left and fight sides.
Install or Connect (Figure 48)
Tool Required:
J 22517-C Torsion Bar Unloading Tool
1.
Torsion bar (182).
^
Note the location of the paint stripe at the rear end of the torsion bars. There are different bars for the left and right sides.
^
Make sure the bars (182) are on their respective sides.
2.
Torsion bar anchor adapter (188).
A.
Install adjustment arm (186).
B.
Slide adapter tube (188) over torsion bar (182) and into adjustment arm (186).
C.
Make sure adapter tube is properly seated into the front face of crossmember and torsion bar is properly seated into rear of the adapter
tube.
D.
The leading edge of the paint stripe (177) must not extend past the front of the frame crossmember (175).
3.
Adjustment retainer plate (185 and bolt (184).
A.
Increase the tension on the torsion bar using J 22517-C.
B.
Install the retaining plate and adjustment bolt.
C.
Set the adjustment bolt to the marked setting from step 1 of the removal procedure.
D.
Release the tension on the torsion bar until the load is taken up by the adjustment bolt.
E.
Remove J 22517-C.
4.
Lower the vehicle
5.
Check the "Z" height. Refer to SECTION 3A.
