Saginaw Integral Power Steering Gear Service and Repair
Steering Gear: Service and Repair
Removal/Installation
1.
Disconnect battery ground cable.
2.
On models equipped with power steering, disconnect pressure and return lines from steering gear housing, then plug hose ends and gear housing
ports to prevent contamination.
3.
On all models, remove pinch bolt from intermediate shaft.
4.
On models equipped with power steering, remove the universal yoke from the stub shaft.
5.
Remove pitman arm nut and washer from pitman shaft, then mark relationship between shaft and arm for assembly reference.
6.
Remove pitman arm using pitman arm remover J-29107 for models equipped with power steering and J-6632 or J-5504-D for models equipped
with manual steering. or equivalent.
7.
Remove steering gear frame bolts and washers, then the steering gear.
8.
Reverse procedure to install. Tighten intermediate shaft pinch bolt and pitman shaft nut to specifications.
