Safari Van AWD V6-4.3L VIN W (1996)
IMPORTANT: The replacement VCM is supplied without a KS Calibration PROM so for reuse in the new VCM carefully remove the PROM from the
defective VCM.
5. Remove the Calibration PROM.
^
Using the thumb and first finger, remove the KS Calibration PROM by gently squeezing each end of the blue KS Calibration PROM. Pull
upward.
^
Do not remove the cover of the KS Calibration PROM. Use of an unapproved KS Calibration PROM removal methods may cause damage to
the KS Calibration PROM or the socket.
6. Inspect for the alignment notches of the KS Calibration PROM.
7. Carefully set it aside.
8. Do not open the KS Calibration PROM.
9. Remove the new VCM from the packaging. Check the service number in order to make sure it is the same as the defective VCM.
10. Remove the access cover.
INSTALLATION PROCEDURE
IMPORTANT: Press only on the ends of the KS Calibration PROM. The small notches in the KS Calibration PROM must align with the small notches
in the KS Calibration PROM socket. Gently press on the KS Calibration PROM until it is firmly seated in the socket. Listen for the click.
1. Install the KS Calibration PROM in the KS Calibration PROM socket.
2. Install the access cover on the VCM.
3. Install the VCM in the engine compartment.
4. Install the connectors to the VCM.
5. The MIL, antilock and brake lamps will continue to be enabled until the VCM is programmed. Once the programming is complete, the lamps will
turn off and normal operation will occur.
6. Connect the negative battery cable.
NOTE: The ignition should always be OFF when installing or removing the VCM connectors.
