Safari Van M V6-262 4.3L VIN Z TBI (1990)
Front Crankshaft Seal: All Technical Service Bulletins
Crankshaft Front Seal - Oil Leak
GMC NUMBER:
91-6A-16
GROUP:
6A ENGINE MECHANICAL
DATE:
SEPTEMBER, 1990
CORPORATE
NUMBER:
036106R
SUBJECT:
OIL LEAK AT FRONT CRANKSHAFT SEAL
MODELS:
1990 S/T, C/K, G, P, M/L, AND 1991 S/T TRUCKS WITH 4.3L ENGINES
CONDITION:
Some of the above trucks may exhibit an oil leak at the front of the engine coming from between the crankshaft seal and timing chain cover.
CAUSE:
This condition may be caused by inadequate retention of the crankshaft seal in the timing chain cover.
CORRECTION:
To correct this condition a new front crankshaft seal must be installed per the following instructions.
1.
Remove old seal per Service Manual section 6A.
2.
Thoroughly clean the hole in the timing cover and metal outside diameter of the new seal. Wipe both surfaces using a clean rag damp with brake
cleaner solvent, isopropyl (rubbing) alcohol or Loctite 755 cleaning solvent.
Important
Do not use gasoline, diesel fuel, kerosene, or solvents which may leave a residue or deteriorate the seal.
3.
Inspect cover hole for any damage. If damage is apparent replace cover assembly. If there is no damage continue to step 4.
4.
Apply a bead of Loctite 680 retaining compound around the metal outside diameter of
the new seal and install the seal per the service manual using tool J-35468.
Important
Do not use RTV in place of Loctite 680 to install the new seal.
Parts are currently available through GMSPO. We believe this source and their equipment to be reliable. There may be additional manufacturers of such
equipment. General Motors does not endorse, indicate any preference for or assume any responsibility for the products or equipment trom this firm or for
any such items which may be available from other sources."
WARRANTY INFORMATION For vehicles repaired under warranty use:
