Safari Van M V6-262 4.3L VIN Z TBI (1990)
FIGURE 1
INSTRUCTIONS: (Refer to Figure 1)
1.
Remove engine cover.
2.
Detach the floor air outlet assembly (P/N 15601727), located near the gas pedal and engine cover, from the air distributor assembly by removing
two screws (P/N 11508917) and two washers (P/N 2077521). Slide the floor air outlet assembly to the right being careful not to break off the
guide retainers molded into the top of the air outlet assembly.
3.
Use a hacksaw or other appropriate cutting tool to remove a small four-sided section of the floor air outlet assembly as shown in Figure 1.
Cut along the top and the left side of the cut-out area only. A smaller almost triangular area located between the existing open area and the cut-out area
should remain intact.
4.
Reinstall the floor air outlet assembly onto the air distributor assembly using the two previously removed screws and washers. Torque the screws
to 1.2 to 1.6 N-m (11 to 14 in.lbs.).
PARTS INFORMATION New parts are not necessary unless the existing parts are lost or damaged during removal and replacement. The part numbers
listed below are for information purposes only:
