Savana 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
1. Install the brake pipe to the vehicle.
2. Install the brake pipe retaining clips to the frame.
3. Connect the rear brake pipe and/or the front brake pipe to the EBCM unit.
^
Tighten the brake pipe to the EBCM unit to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Connect the brake pipe to the brake master cylinder.
^
Tighten the brake pipe to the master cylinder to 30 Nm (22 ft. lbs.).
5. Bleed the brake hydraulic system. Refer to Hydraulic Brake System Bleeding (Manual Bleeding) or Hydraulic Brake System Bleeding (Pressure
Bleeding).
