Savana 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
2.
Remove the side front door front garnish molding. Refer to the Front Side Door Front Garnish Molding procedure in this bulletin.
3.
Remove the nuts that retain the mirror to the door.
4.
Detach the mirror from the door. It should not be necessary to disconnect the mirror harness from the door.
5.
Cut a slit into the grommet enough to surround the mirror cord.
6.
Place the grommet around the mirror cord behind the mirror in the area shown above. The grommet will seat between the mirror and the sheet
metal when the mirror is installed.
7.
Place the mirror back into position on the door.
8.
Install the nuts that retain the mirror to the door. Tighten
Tighten the nuts to 10 Nm (89 lb in).
9.
Install the front side door front garnish molding. Refer to the Front Side Door Front Garnish Molding procedure in this bulletin.
Outside Rear View Mirror Patch Gasket (Manual Mirrors Only)
A revised mirror patch gasket, P/Ns 12477914 (RH) and 124779191 (LH), has been developed that attaches to the back side of the mirror. The shape of
the gasket has been revised in order to reduce windnoise. Use the following procedure.
1.
Open the door.
2.
Remove the front side door front garnish molding. Refer to the Front Side Door Front Garnish Molding procedure in this bulletin.
3.
Remove the nuts that retain the mirror to the door.
4.
Remove the mirror from the door.
5.
Remove the current gasket from the back of the mirror.
