Savana 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
11. Remove the propeller shaft from the transmission.
12. Clean all parts with an approved solvent.
13. Inspect the outer surface of the front slip yoke for burrs. Burring damages the transmission seal.
14. Inspect for proper installation and uniform seating of the bearing cups.
15. Inspect the slip yoke splines for wear.
16. Inspect for twisted slip yoke splines or the wrong universal joint.
INSTALLATION PROCEDURE
1. Lubricate the slip yoke splines.
2. Install the front propeller shaft into the transmission lining up the index splines.
3. Install the bolts (3) at the center bearing support (5) to the center bearing hanger (1).
^
Tighten the center bearing retaining bolts to 58 Nm (43 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
