Savana 1/2 Ton Van V8-5.3L VIN T (2003)
3. Install the brake hose to the bracket.
4. Remove the rubber cap or plug from the exposed brake pipe fitting end.
5. Connect the brake pipe fitting to the brake hose.
-
Use a backup wrench on the hose fitting.
-
Do not bend the bracket or the pipe.
Tighten the fitting to 25 Nm (18 ft. lbs.).
6. Install the brake hose retaining clip to the hose mounting bracket.
7. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
8. Bleed the hydraulic brake system.
9. Lower the vehicle.
