Savana 1/2 Ton Van V8-5.3L VIN T (2003)
Engine Mount: Service and Repair
Engine Mount Replacement - Right
Engine Mount Replacement - Right
Removal Procedure
Notice: Refer to Engine Mounting Notice in Service Precautions.
1. Raise and support the vehicle. Refer to Vehicle Lifting
2. Remove the starter.
3. Remove the right side exhaust manifold.
4. Remove the engine mount to the frame mounting bolts.
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking
against the oil pan may cause it to crack or break.
Important: Raise the engine only enough to permit removal of the engine mount.
5. Using a jack on the square tab at the rear of the engine block and raise the engine, left side shown.
