Savana 1/2 Ton Van V8-5.3L VIN T (2003)
6. Remove the retaining nut (3) from the evaporator inlet tube (5).
7. Remove the evaporator inlet tube from the evaporator.
8. Remove the sealing washers.
9. Remove the screws (2) from the evaporator and blower module assembly.
10. Remove the evaporator and blower module assembly front cover (3).
11. Remove the recirculation door actuator (7) and the linkage.
INSTALLATION PROCEDURE
1. Install the recirculation door actuator (7) and the linkage.
2. Install the evaporator and blower module assembly cover (3).
3. Install the screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
