Savana 1/2 Ton Van V8-5.3L VIN T (2003)
Tail Lamp: Service and Repair
Tail Lamp Replacement
TAIL LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Remove the upper quarter panel applique.
2. Remove the nuts (2) that retain the tail lamp to the upper quarter panel.
3. Remove the center high mounted stop lamp lens (2) from the center high mounted stop lamp applique (1).
4. Disconnect the bulb sockets from the tail lamp (3).
5. Remove the bulbs from the sockets by turning the bulbs in a counterclockwise direction.
INSTALLATION PROCEDURE
1. Install the bulbs into the sockets by turning the bulbs in a clockwise direction.
2. Connect the bulb sockets into the tail lamp (3).
3. Install the tail lamp retaining nuts (2) to the upper quarter panel.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the nuts to 5 N.m (44 lb in).
4. Install the upper quarter panel applique.
