Savana 1/2 Ton Van V8-5.3L VIN T (2003)
1.
On front seats, lift the buckle sleeve at the bottom to expose the bolt.
2.
On front seats, remove the seat belt buckle retaining bolt from the seat.
3.
On front seats, disconnect the buckle sensor wire.
4.
On front seats, slide the buckle sleeve down to expose the buckle.
5.
Insert the latch into the buckle and leave it inserted throughout the cover replacement procedure.
6.
Remove the buckle cover.
6.1.
Holding the lower half of the buckle in one hand, put the thumb of the opposite hand in the area where the belt loops through the buckle.
6.2.
Using the thumb, push the cover over and then up and away from the lower half; the clip should release.
6.3.
Push the cover in the opposite direction to release the other side.
6.4.
Lift the back of the cover to disengage the front.
7.
Install the new cover.
