Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Tighten the bolts to 12 Nm (9 ft. lbs.).
9. Install the right front, left front and rear brake pipes to the tube adapters.
^
Tighten the front brake pipe fittings to 20 Nm (16 ft. lbs.).
^
Tighten the rear brake pipe fitting to 30 Nm (22 ft. lbs.).
10. Install the front and rear brake pipes (from master cylinder) to the combination valve.
Tighten the brake pipe fittings to 30 Nm (22 ft. lbs.).
11. Connect the electrical connector to the combination valve.
12. Connect the electrical connectors to the EBCM.
13. Install the EHCU shield.
Tighten the bolts to 12 Nm (8 ft. lbs.).
14. Lower the vehicle.
15. Bleed the brake system. Refer to Automated Bleed Procedure.
Important: Verify that the combination valve metering rod is depressed during bleeding.
16. Return to Diagnostic System Check. Refer to Diagnostic System Check - ABS.
