Savana 1/2 Ton Van V8-5.7L VIN R (2001)
1. Install the rear brake hose to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the junction block retaining bolt to the rear axle.
Tighten the junction block retaining bolt to 20 Nm (15 ft. lbs.).
3. Uncap or unplug the rear brake pipes and connect the pipes to the junction block on the axle.
Tighten the rear brake pipes to the brake hose to 20 Nm (15 ft. lbs.).
Important: The hose must not be twisted. Make sure the hose is not in contact with any suspension component.
4. With the weight of the vehicle on the suspension, install the brake hose into the bracket.
5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
6. Connect the brake pipe fitting nut to the brake hose:
^
Use a backup wrench on the hose fitting.
^
Do not bend the bracket or the pipe.
Tighten
Tighten the rear brake pipes to the brake hose to 20 Nm (15 ft. lbs.).
7. Bleed the hydraulic brake system.
