Savana 1/2 Ton Van V8-5.7L VIN R (2001)
^
If the rotor segment does not come within a few degrees of the pointer, repeat the procedure again in order to achieve the proper alignment.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
7. Install the distributor mounting clamp bolt.
Tighten
Tighten the bolt to 25 Nm (18 lb ft).
8. Install the distributor cap.
9. Install the new distributor cap screws.
Tighten
Tighten the screws to 2.4 Nm (21 lb in).
10. Install the electrical connector to the distributor.
11. Install the spark plug wires to the distributor cap.
