Savana 1/2 Ton Van V8-5.7L VIN R (2001)
1. Apply a small amount of dielectric silicone grease GM P/N 12345579 in both boots of the spark plug wires.
2. Install the coil wire to the coil and the distributor.
3. Install the spark plug wires at the distributor.
4. Install the spark plug wire to each spark plug on the right side of the engine.
5. Install the spark plug wire to each spark plug on the left side of the engine.
6. Install the spark plug wires in the clips.
7. Inspect the wires for proper installation:
^
Push sideways on each boot in order to inspect the seating.
^
Reinstall any loose boot.
^
Wire routings must be kept intact during service and followed exactly when wires have been disconnected or when replacement of the wires is
necessary. Failure to route the wires properly can lead to radio ignition noise and cross-tiring of the plugs, or shorting of the leads to the
ground.
8. Install the engine cover.
