Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Oil Pressure Sender: Service and Repair
ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT
TOOLS REQUIRED
J 41712 Oil Pressure Switch Socket
REMOVAL PROCEDURE
1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Computers and Controls Systems - 5.7L.
3. Disconnect the electrical connector from the engine oil pressure (EOP) gauge sensor.
4. Hold the EOP gauge sensor fitting with a wrench.
IMPORTANT: Note the alignment of the EOP gauge sensor fitting prior to removal.
5. Remove the EOP gauge sensor using J 41712.
6. Remove the EOP sensor fitting, if necessary.
INSTALLATION PROCEDURE
