Savana 1/2 Ton Van V8-5.7L VIN R (2001)
11. As the distributor is being removed from the engine, watch the rotor move in a counter-clockwise direction about 42 degrees. This will appear as
slightly more than one clock position.
12. Note the position of the rotor segment.
13. Place a second mark on the base of the distributor (2). This will aid in achieving the proper rotor alignment during the distributor installation.
Installation Procedure 1
1. If installing a new distributor assembly, place 2 marks on the new distributor housing in the same location as the marks on the original housing.
2. Remove the new distributor cap, if necessary.
Important: Use a long screwdriver in order to align the oil pump drive shaft to the drive tab of the distributor.
3. Align the rotor with the second mark (2).
