Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Accelerator Pedal: Service and Repair
ACCELERATOR CONTROLS PEDAL REPLACEMENT
REMOVAL PROCEDURE
1. Lift upward on the accelerator pedal (3) to relieve tension on the cable (2).
2. Remove the retainer from the accelerator pedal lever hole.
3. Remove the cable from the slot in the accelerator pedal lever.
4. Remove the accelerator pedal mounting bolts.
5. Remove the accelerator pedal.
INSTALLATION PROCEDURE
IMPORTANT: The accelerator cable is not to be kinked or damaged in any way during installation.
1. Ensure that the mounting surface between the accelerator pedal assembly and the dash panel is free of insulation. The carpet and padding in the
pedal and tunnel area must be positioned to lay flat and be free of wrinkles and bunches. Wire, hoses, cables, and other flexible components should
not be within 13 mm (0.52 in) of the cable or lever, at any point in their travel.
2. Install the accelerator pedal to the dash panel.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the accelerator pedal mounting bolts.
Tighten
Tighten the bolts to 5 N.m (44 lb in).
