Savana 1/2 Ton Van V8-5.7L VIN R (2001)
8. Remove the bolt (3) that secures the lower mounting cup (1) to the bumper.
9. Separate and remove the fill valve and the mounting cup assembly from the vehicle.
INSTALLATION PROCEDURE
1. Place the lower mounting cup (3) against the vehicle bumper (1).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the lower cup (1) mounting bolt (3) rotating the cup so that the drain hole is on the bottom.
Tighten
Tighten the bolt to 12 N.m (106 lb in).
3. Install the fill valve into the mounting cup.
