Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Ignition Cable: Service and Repair
Spark Plug Wire Replacement
REMOVAL PROCEDURE
1. Remove the engine cover.
2. Disconnect the spark plug wire at each spark plug on the left side of the engine.
^
Twist the boots 1/2 turn before removing the boots.
^
Pull only on the boot or use a tool designed for this purpose in order to remove the wire from each spark plug.
3. Disconnect the spark plug wire at each spark plug on the right side of the engine.
^
Twist the boots 1/2 turn before removing the boots.
^
Pull only on the boot or use a tool designed for this purpose in order to remove the wire from each spark plug.
4. Disconnect the spark plug wire from the distributor.
^
Twist each spark plug boot 1/2 turn.
^
Pull only on the boot or use a tool designed for this purpose in order to remove the wires from the distributor.
5. Remove the spark plug wires from the wire clips.
6. Remove the coil wire from the distributor and the coil.
INSTALLATION PROCEDURE
NOTE: Refer to Spark Plug Boot Notice in Service Precautions.
