Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Brake Light Switch: Service and Repair
Stoplamp Switch Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the battery negative cable.
2. Disconnect the electrical connector from the stoplamp switch.
3. Remove the retainer from the brake pedal pin.
4. Remove the stoplamp switch and the pushrod to the power brake booster from the brake pedal pin.
5. Unsnap the stoplamp switch from the power brake booster pushrod.
Installation Procedure
1. Snap the stoplamp switch onto the pushrod to the power brake booster.
2. Install the stoplamp switch with the pushrod on the brake pedal pin.
3. Connect the electrical connector to the stoplamp switch.
4. Connect the battery negative cable.
