Savana 1/2 Ton Van V8-5.7L VIN R (2001)
1. Install the connecting rod to the pitman arm.
Notice: Refer to Fastener Notice in Service Precautions.
2. Use the J 29193 in order to seat the connecting rod ball stud to the pitman arm.
Ensure that the seal is on the ball stud.
-
Tighten the J 29193 to 54 Nm (40 ft. lbs.) in order to seat the tapers.
3. Remove the J 29193.
4. Install the new prevailing torque nut (2) to the connecting rod (4) ball stud at the pitman arm.
-
Tighten the nut to 47 Nm (35 ft. lbs.).
5. Use the J 29193 in order to seat the tapers at the connecting rod ball stud to the relay rod.
Ensure that the seal is on the stud.
