Savana 1/2 Ton Van V8-5.7L VIN R (2001)
4. Remove the pitman arm nut and washer.
Mark the pitman arm and the pitman shaft in order to properly align at reassembly.
Notice: Do not hammer on the pitman arm, pitman arm shaft or puller. Damage to the pitman arm or steering gear may result.
5. Remove the pitman arm using the J 6632-01, or the J 29107-A.
6. Clean the threads on the ball stud and the ball stud nut.
7. Inspect the ball stud threads for damage.
8. Inspect the ball stud seals for excessive wear.
Installation Procedure
Notice: If a clamp-type pitman arm is used, spread the pitman arm just enough with a wedge to slip the arm onto the pitman shaft. Do not spread the
pitman arm more than required to slip over the pitman shaft with hand pressure. Do not hammer. Damage to the steering gear may result.