Savana 1/2 Ton Van V8-5.7L VIN R (2001)
1. Install the pitman arm on the pitman shaft.
Line up the marks made at removal.
Use a new torque prevailing nut.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the pitman arm washer and nut.
-
Tighten the pitman arm retaining nut to 250 Nm (184 ft. lbs.).
3. Connect the connecting rod (4) to the pitman arm (3) ball stud.
Make sure the seal is on the stud.
-
Tighten the J 29193, or the J 29194 to 54 Nm (40 ft. lbs.) in order to seat the tapers.
4. Remove the J 29193. Install a new torque prevailing nut.
-
Tighten the connecting rod nut to 47 Nm (35 ft. lbs.).
5. Remove the safety stands.
6. Lower the vehicle.
