Savana 1/2 Ton Van V8-5.7L VIN R (2001)
3. Install the steering gear outlet hose (4) to the steering gear (2).
-
Tighten the hose fitting to 27 Nm (20 ft. lbs.).
4. Install the power steering outlet hose (1) to the steering pump (3).
5. Check the power steering fluid level. Refer to Checking and Adding Power Steering Fluid.
6. Remove the drain pan from under the vehicle.
7. Bleed the power steering system.
Power Steering Reservoir Inlet Pipe/Hose Replacement
Power Steering Reservoir Inlet Pipe/Hose Replacement
Removal Procedure
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
1. Install a drain pan under the vehicle.
2. Siphon the fluid from the reservoir to prevent excessive spillage.
3. Remove the reservoir inlet hose (3) from the brake booster (2).
4. Remove the reservoir inlet hose (3) from the reservoir.
5. Remove the hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.