Savana 1/2 Ton Van V8-5.7L VIN R (2001)
Installation Procedure
1. Remove the rear servo assembly from the transmission case as follows:
^
Accumulator spring (14).
^
Selective pin (13).
^
Servo spring retainer (12).
^
Servo spring (11).
^
Washer (10).
^
Piston seal (9).
^
Accumulator piston (8).
^
Inner ring oil seal (7).
^
Outer ring oil seal (1).
^
Servo piston (2).
^
Bottom retaining clip (3).
^
Cover gasket (4).
^
Cover (5).
^
Cover Bolt (6).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the cover bolts.
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
3. Install the transmission oil pan and filter.
Forward Servo Replacement
Forward Servo Replacement
Removal Procedure
1. Lift the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan and filter.
