Savana 1500 RWD V6-4.3L (2007)
8. Remove the bolts (4) securing the BPMV (1) to the EHCU mounting bracket (3).
9. Disconnect the 2-way ABS pump motor connector.
Important: Do not reuse the EBCM mounting bolts. Always install new bolts.
10. Remove the bolts from the EBCM (2).
Important: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
11. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
12. Clean the EBCM to BPMV mounting surfaces with a clean cloth.
Installation Procedure
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
1. Install the EBCM (2) onto BPMV (1).
Notice: Refer to Fastener Notice.
Important: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.
2. Install the EBCM bolts.
Tighten the bolts to 5 N.m (44 lb in) in an X-pattern.
3. Connect the 2-way ABS pump motor connector to the EBCM.
4. Install the BPMV (1) to EHCU bracket (3).
