Savana 1500 RWD V6-4.3L (2007)
1. Install the anti-rattle clips to the brake caliper bracket.
2. Install the brake caliper.
3. Install the brake pads to the brake caliper bracket. Place the new pads in the same orientation as noted during removal.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling.
10. Burnish the brakes pads and rotors as necessary. Refer to Brake Pad and Rotor Burnishing.
